|
This thread is carried over and continued in the Current Elsmar Cove Forums 
|
|
|
This thread is carried over and continued in the Current Elsmar Cove Forums
|
The New Elsmar Cove Forums
|
 The New Elsmar Cove Forums
 Measurement, Test and Calibration
 Chicago Brand Bore Gauges
|
 UBBFriend: Email This Page to Someone! |
next newest topic | next oldest topic |
| Author | Topic: Chicago Brand Bore Gauges |
|
victorstephenson unregistered |
posted 07 September 2000 04:57 PM
 
Does anyone have experience with CHICAGO BRAND dial bore gauges? Their prices (at $75 to $100) are much cheaper (about 1/4th the cost) than SUNNEN. They also make micrometers and dial indicators. ?? IP: Logged |
|
Marc Smith Cheech Wizard Posts: 4119 |
posted 10 September 2000 09:26 PM
 
I haven't off hand. You might try Greg Gogates' listserve - I think Greg's e-mail is [email protected] IP: Logged |
|
Steven Truchon Forum Contributor Posts: 89 |
posted 13 September 2000 11:23 AM
I've used Chicago dial indicators in the past. Never had any problems. They seem to be very sturdy and reliable in general terms. When you get into the .0001 increment instruments however, Chicago is much like the InterRapid .0001 indicators in that one must sift through a number of them to find one that repeats. Most do not repeat and when one is found, BUY IT as it will serve you well for years! IP: Logged |
All times are Eastern Standard Time (USA) | next newest topic | next oldest topic |
  |
Hop to: |
Your Input Into These Forums Is Appreciated! Thanks!
Main Site Search 
