|
This thread is carried over and continued in the Current Elsmar Cove Forums 
|
|
|
This thread is carried over and continued in the Current Elsmar Cove Forums
|
The New Elsmar Cove Forums
|
 The New Elsmar Cove Forums
 Measurement, Test and Calibration
 gage for checking of rounding of gears and doubts on stability
|
 UBBFriend: Email This Page to Someone! |
next newest topic | next oldest topic |
| Author | Topic: gage for checking of rounding of gears and doubts on stability |
|
Franky Lurker (<10 Posts) Posts: 1 |
posted 25 October 2000 01:18 PM
   
we have identified rounding of spur gear teeth as as SC characteristic,but we do not have a gage to check .....any suggestions?? Also, is it a must for stability to be done simultaneously with Gage R&R studies..or does it have to be done when the methods are standardised and parts are checked by a standard operating procedure,decided after IP: Logged |
|
Marc Smith Cheech Wizard Posts: 4119 |
posted 26 November 2000 09:40 PM
I think the M&M company makes suc a gage. M&M may not be the company name - at Ford Sharonville they had gages they called the M&M's which, as I remember, measured these characteristics. You might call the Ford Sharonville (Ohio) plant metrology folks and ask. IP: Logged |
|
Marc Smith Cheech Wizard Posts: 4119 |
posted 26 November 2000 09:41 PM
By the way, Ford Sharonville is a transmission plant. They measure all sorts of stuff on gears - tooth angles, surface roughness, etc. IP: Logged |
All times are Eastern Standard Time (USA) | next newest topic | next oldest topic |
  |
Hop to: |
Your Input Into These Forums Is Appreciated! Thanks!
Main Site Search 
