|
This thread is carried over and continued in the Current Elsmar Cove Forums 
|
|
|
This thread is carried over and continued in the Current Elsmar Cove Forums
|
The New Elsmar Cove Forums
|
 The New Elsmar Cove Forums
 Measurement, Test and Calibration
 Test lab/calibration humidity requirement
|
 UBBFriend: Email This Page to Someone! |
next newest topic | next oldest topic |
| Author | Topic: Test lab/calibration humidity requirement |
|
BOBSKY unregistered |
posted 16 January 2001 12:41 PM
 
Our objective in the near future is to be compliant to the latest requirements, I have heard 50% humidity is spec. for ambient temp of 65 to 75 degrees does anyone know where this is written? our lab is 21 c and usually around 23% humidity, how many dollars required to bump to 50% if required? and contacts in Ontario Canada. THANKS BOBSKY. IP: Logged |
|
TorqueGuy Forum Contributor Posts: 10 |
posted 18 January 2001 11:29 AM
 
I have found some ISO specs for test and calibration that state required temperature but not humidity. I think it depends on the type of M&T's being performed. What are you calibrating? IP: Logged |
|
David Drue Stauffer Forum Contributor Posts: 25 |
posted 18 January 2001 03:15 PM
Hi, If you would acquire ASME B89.6.2 entitled " Temperature and Humidity Environment for Dimensional Measurement", I think this will answer your questions. Dave. IP: Logged |
All times are Eastern Standard Time (USA) | next newest topic | next oldest topic |
  |
Hop to: |
Your Input Into These Forums Is Appreciated! Thanks!
Main Site Search 
