|
This thread is carried over and continued in the Current Elsmar Cove Forums 
|
|
|
This thread is carried over and continued in the Current Elsmar Cove Forums
|
The New Elsmar Cove Forums
|
 The New Elsmar Cove Forums
 Measurement, Test and Calibration
 Need to know how to calibrate inch and metric gage blocks correctly.
|
 UBBFriend: Email This Page to Someone! |
next newest topic | next oldest topic |
| Author | Topic: Need to know how to calibrate inch and metric gage blocks correctly. |
|
brossbach unregistered |
posted 19 February 2001 10:37 AM
 
Need to perform a very accurate calibration on gage blocks. Inches and Metric. Is there anybody out there who knows how to do it correctly. IP: Logged |
|
Jerry Eldred Forum Wizard Posts: 136 |
posted 19 February 2001 10:52 AM
 
If you can ask some more specific details, I can probably get you a good answer. I am not the mechanical guru, but can pass this along to him. Additionally, I have access to some good procedures. If you'd prefer, email me directly for a more detailed answer at [email protected] ------------------ IP: Logged |
|
Ryan Wilde Forum Contributor Posts: 20 |
posted 19 February 2001 08:14 PM
quote:
If you are in the USA, the standards that apply are ANSI/ASME B89.1.2M and ANSI/ASME B89.1.9M. The older standard is GGG-G-15C, which is available for FREE at ASSIST online http://astimage.daps.dla.mil/quicksearch/ . Type "15" in the Document Number field, then scroll to the document. Hope that helps a little! ------------------ IP: Logged |
All times are Eastern Standard Time (USA) | next newest topic | next oldest topic |
  |
Hop to: |
Your Input Into These Forums Is Appreciated! Thanks!
Main Site Search 
