The Elsmar Cove Business Standards Discussion Forums More Free Files Forum Discussion Thread Post Attachments Listing Elsmar Cove Discussion Forums Main Page
Welcome to what was The Original Cayman Cove Forums!
This thread is carried over and continued in the Current Elsmar Cove Forums

Search the Elsmar Cove!

Wooden Line
This is a "Frozen" Legacy Forum.
Most links on this page do NOT work.
Discussions since 2001 are HERE

Owl Line
The New Elsmar Cove Forums   The New Elsmar Cove Forums
  Measurement, Test and Calibration
  Calibration Work Instruction Examples

Post New Topic  Post A Reply
profile | register | preferences | faq | search

UBBFriend: Email This Page to Someone! next newest topic | next oldest topic
Author Topic:   Calibration Work Instruction Examples
qaman714
unregistered
posted 22 February 2001 03:14 AM           Edit/Delete Message   Reply w/Quote
Is their a site on the internet where you can get examples of performing calibration of handheld gages that identifies requirements & recommended frequencies? Additionally, some gages we use such as calipers & a comparator result in gage R & R's over 30%. Does the acceptance criteria for gage R&R's vary for different types of gages or is 30% the maxium acceptable no matter what type of gage?

IP: Logged

AJLenarz
Forum Contributor

Posts: 25
From:Princeton, IN, USA
Registered: Feb 2001

posted 22 February 2001 10:23 AM     Click Here to See the Profile for AJLenarz   Click Here to Email AJLenarz     Edit/Delete Message   Reply w/Quote
Since I am dyslexic, I will answer the questions backwards. First the R&R. The MSA manual does not provide any ăHard and Fastä rules about GR&R acceptance criteria. However, they do provide ăguidelinesä for acceptance. (which most customers adopt as gospel) The guidelines are as follows:

Under 10% - measurement system is acceptable

10% - 30% - may be acceptable based upon importance of application, cost of gage, cost of repair

Over 30% - measurement system needs improvement.

You really need to look at the characteristicâs importance, tolerance, gaging technique and technology availability, cost, customerâs needs and expectations· ect to assist you in making these determinations. For example, if you have to develop some exotic gaging utilizing new technology at a very high cost and you have demonstrated that 30% is as good as it is going to get, a customer will most likely accept this. However, if you are measuring a bore and getting 30% error I guarantee you will feel some resistance and hesitation from the customer as the technology is there at reasonable cost to measure this repetitively.

You have to decide in conjunction with your customer what is practical for your business needs. But donât go to your customer with out plenty of ammo to support your argument.

Secondly, the calibration examples. Drop me an e-mail and tell me your needs. Provide me with a fax, and I see what I can muster up for you.

IP: Logged

CarolX
Forum Contributor

Posts: 108
From:Illinois, USA
Registered: Jun 2000

posted 22 February 2001 10:37 AM     Click Here to See the Profile for CarolX   Click Here to Email CarolX     Edit/Delete Message   Reply w/Quote
If you post your e-mail I can send you some examples of calibration procedures. You might want to check the .pdf file also for some other examples.

Regards,

Carol X.

IP: Logged

All times are Eastern Standard Time (USA)

next newest topic | next oldest topic

Administrative Options: Close Topic | Archive/Move | Delete Topic
Post New Topic  Post A Reply Hop to:

Contact Us | The Elsmar Cove Home Page

Your Input Into These Forums Is Appreciated! Thanks!


Main Site Search
Y'All Come Back Now, Ya Hear?
Powered by FreeBSD!Made With A Mac!Powered by Apache!