|
This thread is carried over and continued in the Current Elsmar Cove Forums 
|
|
|
This thread is carried over and continued in the Current Elsmar Cove Forums
|
The New Elsmar Cove Forums
|
 The New Elsmar Cove Forums
 Measurement, Test and Calibration
 stability studies using gage fixtures
|
 UBBFriend: Email This Page to Someone! |
next newest topic | next oldest topic |
| Author | Topic: stability studies using gage fixtures |
|
bayliner Lurker (<10 Posts) Posts: 1 |
posted 09 March 2001 08:18 PM
   
I am hoping that someone can help me out by providing me with some information on performing stability studies on plastic injection molded parts using a fixture gage with digital indicator. Any help in this area will be greatly appreciated. I have been given the task of creating a method and documenting it in the form of work instructions for this type of study. I am of the opinion that performing a stability study using a fixture gage is not needed, however, we were written up for this during our last audit and it must be done. ------------------ [This message has been edited by bayliner (edited 09 March 2001).] IP: Logged |
|
DICKIE Forum Contributor Posts: 46 |
posted 12 March 2001 01:57 PM
Your fixture gage is no different than any other gage. I assume your audit was for QS-9000 so the AIAG'S MSA (measuring systems analysis) book would be a good place to start. Once you perform this study you'll see it's no big deal and will keep your auditor off your back. Just learning the process will give you some backround and allow you to argue your point. IP: Logged |
|
Al Dyer Forum Wizard Posts: 622 |
posted 10 April 2001 06:12 PM
Bayliner, What type of master do you use for the fixture? ASD... IP: Logged |
All times are Eastern Standard Time (USA) | next newest topic | next oldest topic |
  |
Hop to: |
Your Input Into These Forums Is Appreciated! Thanks!
Main Site Search 
