|
This thread is carried over and continued in the Current Elsmar Cove Forums 
|
|
|
This thread is carried over and continued in the Current Elsmar Cove Forums
|
The New Elsmar Cove Forums
|
 The New Elsmar Cove Forums
 Measurement, Test and Calibration
 air gauges
|
 UBBFriend: Email This Page to Someone! |
next newest topic | next oldest topic |
| Author | Topic: air gauges |
|
dwlmson Lurker (<10 Posts) Posts: 1 |
posted 23 April 2001 04:30 PM
   
a customer of ours is purchasing air gages to verify a bore with tight tolerances. How much are the results affected by surface finish of the bore when air gauging is used? IP: Logged |
|
Al Dyer Forum Wizard Posts: 622 |
posted 23 April 2001 05:57 PM
quote: I think it would adversely affect the measurement. R&R/MSA studies (emphasis on stability) should be looked at hard. One variable to take into consideration is whether the gage is on the production floor and subject to more abuse and environmental concerns than if in a controlled lab. Also look into how the variation of air pressure running through the lines in the plant are controlled and how they affect gage readings. From not a gage guy! ASD... IP: Logged |
All times are Eastern Standard Time (USA) | next newest topic | next oldest topic |
  |
Hop to: |
Your Input Into These Forums Is Appreciated! Thanks!
Main Site Search 
