|
This thread is carried over and continued in the Current Elsmar Cove Forums 
|
|
|
This thread is carried over and continued in the Current Elsmar Cove Forums
|
The New Elsmar Cove Forums
|
 The New Elsmar Cove Forums
 Measurement, Test and Calibration
 sine plates, v-blocks, parallel bars
|
 UBBFriend: Email This Page to Someone! |
next newest topic | next oldest topic |
| Author | Topic: sine plates, v-blocks, parallel bars |
|
kristi Lurker (<10 Posts) Posts: 5 |
posted 13 June 2001 01:02 PM
  
I am in need of calibration procedures for sine plates, v-blocks, and parallel bars. Any advice would be helpful. We have an idea of what to do, but not for sure of the exact steps needed to complete calibration. We have a CMM that is accurate up to .0002", but from what I have learned, we would be better off in using a height gage on a surface plate. thanks! IP: Logged |
|
Kevin Mader Forum Wizard Posts: 575 |
posted 13 June 2001 02:32 PM
You are correct. I recall a book from Mcgraw Hill (I think) entitled Gage & Inspection or something close which offers some suggestions on calibration of these devices. In addition, there probably are MIL specs that outline an approach. You'll have to do some research though unless someone here can get you a little closer. Regards, Kevin IP: Logged |
|
Jim Webb Lurker (<10 Posts) Posts: 3 |
posted 18 June 2001 04:07 PM
I have our work instruction which I would be willing to share with you. Contact me at my e-mail address [email protected] if you would like to see it. IP: Logged |
All times are Eastern Standard Time (USA) | next newest topic | next oldest topic |
  |
Hop to: |
Your Input Into These Forums Is Appreciated! Thanks!
Main Site Search 
