|
This thread is carried over and continued in the Current Elsmar Cove Forums 
|
|
|
This thread is carried over and continued in the Current Elsmar Cove Forums
|
The New Elsmar Cove Forums
|
 The New Elsmar Cove Forums
 Documentation
 Documentation
|
 UBBFriend: Email This Page to Someone! |
next newest topic | next oldest topic |
| Author | Topic: Documentation |
|
Dawn Forum Contributor Posts: 245 |
posted 18 September 1998 06:38 PM
   
Are pencil markings on customer prints, tooling prints, or any other quality document for that matter a violation of QS-9000? IP: Logged |
|
Marc Smith Cheech Wizard Posts: 4119 |
posted 20 September 1998 06:48 AM
Depends upon what the markings are but the rule of thumb is if is a working document any alterations or notes should be initialed and dated. In addition, your procedure which defines your controls on documents (in this case prints) has to support it (define conditions of use, so to speak). IP: Logged |
All times are Eastern Standard Time (USA) | next newest topic | next oldest topic |
  |
Hop to: |
Your Input Into These Forums Is Appreciated! Thanks!
Main Site Search 
