|
This thread is carried over and continued in the Current Elsmar Cove Forums 
|
|
|
This thread is carried over and continued in the Current Elsmar Cove Forums
|
The New Elsmar Cove Forums
|
 The New Elsmar Cove Forums
 Documentation
 Incoming Material Inspection Plans
|
 UBBFriend: Email This Page to Someone! |
next newest topic | next oldest topic |
| Author | Topic: Incoming Material Inspection Plans |
|
FC Larson Lurker (<10 Posts) Posts: 3 |
posted 07 April 1999 10:28 PM
   
I would like to start labeling CTQs or Critical to Quality features on our drawings as an integral part of our incoming inspection plans for each part. Does a standard symbol or format exist for doing this? IP: Logged |
|
Marc Smith Cheech Wizard Posts: 4119 |
posted 08 April 1999 11:10 AM
I know of no 'industry standard' or other standard. If you look at QS9000 Appendix C you can see in automotive there are a number of designators used by each of the big three. I suggest you choose anything other than one of these to avoid confusion. You could get creative and take a tiny picture of a scowling face and use it for your 'symbol'! Don't forget to document (define) it whatever you decide to use. [This message has been edited by Marc Smith (edited 04-08-99).] IP: Logged |
All times are Eastern Standard Time (USA) | next newest topic | next oldest topic |
  |
Hop to: |
Your Input Into These Forums Is Appreciated! Thanks!
Main Site Search 
