Posts: 275
From:ILLINOIS
Registered: Mar 2000

posted 19 September 2000 09:50 AM               

---

Anyone have a copy or information on the document ISO 2553? - it has been vaguley referenced in one of our customers welding specifications & I believe it has to do with describing weld drawing symbols BUT.. we currently do not have more or any-other information than that.

Thanks
Jim

[This message has been edited by Jim Biz (edited 19 September 2000).]

IP: Logged

Posts: 275
From:ILLINOIS
Registered: Mar 2000

posted 27 September 2000 03:35 PM               

---

Guess maybe we should just write this one off to a customer that dosen't update his own procedures to current ISO references?

If 1118 folks world wide have never heard of it - it must be buried back on some old dusty shelf somewhere Even the customers rep couldn't give me a good explaination of why it was referenced...

Regards
Jim

IP: Logged

Posts: 248
From:Adelaide, South Australia, Australia
Registered: Nov 1999

posted 27 September 2000 10:25 PM               

---

http://www.iso.ch/cate/d7501.html
ISO 2553:1992
Welded, brazed and soldered joints -- Symbolic representation on drawings

The draftsman's note to himself perhaps?

------------------

IP: Logged

Posts: 275
From:ILLINOIS
Registered: Mar 2000

posted 28 September 2000 07:55 AM               

---

Thanks David: We'll make good use of the info-link.. In this case there were no symbols used that were uncommon on any other weld drawings we have. That may be what added to the confusion - quite possible it was used as a draftsman's note to himself as much as anything.

Regards
Jim

IP: Logged

All times are Eastern Standard Time (USA)