Product Acceptance Software (PAS) PROCEDURE (BOEING D6-51991)

[Machineit]

Does anyone have a "Procedure" to share covering "Product Acceptance Software (PAS)" in machining?

 

[Machineit]

Per the BOEING D6-51991 document requirements. Any guidance in writing a Procedure for this is greatly appreciated.
Thanks in Advance!

 

[Cari Spears]

Hi!

We have a CMM using PC-DMIS and Faro laser trackers using Verisurf. We have an artifact - which is just a machined piece of aluminum with features that are representative of the types of features we have on our products - that we sent out to an independent inspection house. Then we inspected the artifact and compared our results to the outside inspection results. Whenever we update the inspection software, we inspect the artifact again.

We have a documented set up sheet for inspecting the artifact, and this section in our DPD procedure:

 

[Machineit]

Hi!

We have a CMM using PC-DMIS and Faro laser trackers using Verisurf. We have an artifact - which is just a machined piece of aluminum with features that are representative of the types of features we have on our products - that we sent out to an independent inspection house. Then we inspected the artifact and compared our results to the outside inspection results. Whenever we update the inspection software, we inspect the artifact again.

We have a documented set up sheet for inspecting the artifact, and this section in our DPD procedure:

View attachment 28916

Your response has help guide me in the right direction. Thank you!