Gauge Design Tolerances - How to decide tolerances for gauge design?

How to decide tolerances for gauge design? Suppose there are two pins of Diameter 8.2 +0.010mm and drawing tolerance for position between them is 0.06mm. The co-ordinates are 71.67 mm and 24mm. What tolerance to be given for holes on gauge and for coordinates 71.67 & 24?

Can any of our Gage Design Experts help?

Thank you!

Stijloor.

I'm giving this one another 'bump'.

Can anyone help with this one? My Thanks in advance!

BTW - Have you looked through these existing discussion threads? --> Gage Tolerances

Hello there gage builder student,
The answer for these question brings up questions.
It sounds as if you want to make a gage to check pin size and alignment?
You offer the pin size and spacing tolorance.
The coordiate locations of the pins have single measurements.
I would guess the pins are on a flat surface? and so might need X/Y coordinates?
The gage's hole diameter, and pin coordinate accuracies could inter-relate.
A bit more info might allow a better comment or answer.
Better advice is likely to follow.