M
mboucher
Ok, take off the PEL and screw the TP200 on the PH10 and go through the Auto-Cal routine making sure your Calibration Sphere is the right dia. It is printed on the shaft of the Master Ball.
Now just touch the top of the master ball and the probe probes the master ball several times, first to get the location and calibrate the master ball, then calibrate the sphere information.
Then use this to measure the rack and you should be done.
Mark Boucher
Now just touch the top of the master ball and the probe probes the master ball several times, first to get the location and calibrate the master ball, then calibrate the sphere information.
Then use this to measure the rack and you should be done.
Mark Boucher