J
jfbock
I know this may be a difficult issue and probably has been from the beginning of time but here it goes.
In our case, not often but once in a while our fabricators miss a weld. I would guess human error is to be expected but our customer simply has no tolerance for it. One solution is 100% inspection, but that's stop gap and isn't addressing the core issue.
Aside from converting to robots (not an option) what suggestions or methods are out there that may be helpful?
In our case, not often but once in a while our fabricators miss a weld. I would guess human error is to be expected but our customer simply has no tolerance for it. One solution is 100% inspection, but that's stop gap and isn't addressing the core issue.
Aside from converting to robots (not an option) what suggestions or methods are out there that may be helpful?